Description
Description: 1500VA 1350W UPS SMART LCD RM AVR 120V
Tripp Lite UPS Smart 1500VA 1350W Rackmount AVR 120V Pure Sine Wave USB DB9 Preinstalled WEBCARDLX 2URM – UPS – AC 120 V – 1.35 kW – 1500 VA – Ethernet, RS-232, USB – output connectors: 8 – 2U – 19″
The SMART1500RM2UN SmartPro 120V 1.5kVA 1.35kW Line-Interactive Sine Wave UPS provides battery backup and AC power protection against blackouts, brownouts, power surges and line noise that can damage electronics or destroy data.
Key Selling Points
Provides fully regulated sine wave AC output for servers, network storage devices and telecom hardware
Audible alarm signals loss of utility power, overload, low battery and fault conditions
8 NEMA 5-15R outlets (4 are switchable)
10 ft. power cord with 120V NEMA 5-15P input
0.9 power factor rating
570-joule surge suppression rating
Supports half load up to 13 min. and full load up to 4.5 min.
Internal batteries designed for hot-swap field replacement
95% line-power efficiency rating saves money in energy costs
Network interface supports simultaneous communications via built-in USB, DB9 serial/contact-closure and pre-installed WEBCARDLX network management card
Allows full remote access for power monitoring, configuration, control and email notifications via secure web browser, SNMP, telnet or SSH
Supports 10/100 Mbps auto-sensing for communication with an Ethernet network
Optional EnviroSense2 sensors (sold separately) enable site monitoring of temperature, humidity and contact-closure status
Can control 4 outlets remotely to reboot equipment or shed nonessential loads
Maintains 120V nominal output over input range of 83V–147V without using battery power
Removes electromagnetic and radio frequency interference that can disrupt or damage equipment’s performance
Front-panel LCD signals operating mode, load level, voltage, battery charge and estimated runtimes
Rotates for easy viewing in rack-mount or tower configurations
USB and DB9 ports enable data-saving unattended shutdown when used with Tripp Lite’s PowerAlert software (available via free download from www.tripplite.com/poweralert)
EPO port supports emergency shutdown in large facilities
Hardware included for 4-post mounting in 2U of EIA-standard 19 in. rack
Mounts on wall or 2-post rack with optional 2POSTRMKITWM accessory
Mounts in upright tower position with optional 2-9USTAND accessory
Reduce Service Calls with Auto Probe Autonomous Device Management. The Auto Probe feature (Firmware 15.5.2 and greater) checks the connectivity status of any networked device and automatically takes one or more user-configured actions if the device fails to respond; actions include outlet reboot, set SNMP traps, SNMP OID sets, and even script execution when used in conjunction with the Tripp Lite PowerAlert Network Shutdown Agent (PANSA)