Description
Description: DVI OVER CAT5 DUAL DISP EXTD SPLITTER
Tripp Lite 2-Port Dual Display DVI over Cat5 / Cat6 Extender Video Splitter TAA – Video extender – over CAT 5 – 4 ports – up to 200 ft – TAA Compliant
Tripp Lite’s B140-002-DD takes in two PC DVI source video signals, and splits each to two remote monitors. Passive, non-powered Receivers allow distances up to 15 m (50-ft.) @ 1920×1200 resolution, or 30.5 m (100-ft.) @ 1024×768 resolution, over solid conductor Cat6 cable. Active, powered Receivers extend the distance to 46 m (150-ft.) @ 1920×1200, and 61 m (200-ft.) @ 1024×768(receivers purchased separately). Additional monitors can be daisy-chained(up to 3) on each channel, allowing four monitors per channel, by using Tripp Lite B140-110 Repeater/Extender. Tripp Lite recommends Cat6 Solid Conductor patch cables for Digital Extenders(DVI/HDMI). Tripp Lite N202-series patch cables are designed specifically for these types of devices…pre-terminated, Solid Conductor Cat6 patch cables up to 61 m (200-ft.) For international use, the B110-INT power supply can be purchased separately; it features plugs for the UK, Europe, and Australia.
Key Selling Points
Transmits a DVI-D Single-Link signal from a set of Dual DVI inputs to two sets of Dual Displays
A B140-Series remote receiver is needed at each monitor
For longer distances: Use a B140-1A0 or B140-1A0-WP active receiver to extend a 1920 x 1080 @ 60Hz signal up to 150 ft. from the transmitter (or a 1024 x 768 @ 60Hz signal up to 200 ft. from the transmitter)
For shorter distances: Use a B140-1P0 or B140-1P0-WP passive receiver to extend a 1920 x 1080 @ 60Hz signal up to 50 ft. from the transmitter (or a 1024 x 768 @ 60Hz signal up to 100 ft. from the transmitter)
Use 24AWG, Solid Wire Cat5e/6 cable, such as Tripp Lite’s N202-Series to achieve maximum distance and resolution
Further expand the range and number of monitors by adding B140-110 remote repeater units
Add up to three repeaters on each of the B140-002-DD channels, for a total of 4 displays per channel (An active receiver should be the last unit in a channel)
A 1920 x 1080 @ 60Hz signal can be extended up to 125 ft. for each repeater added into a channel (or up to 175 ft. for a 1024 x 768 @ 60Hz signal)
DVI 1.0 compliant
HDCP compatible
Mounting hardware included that allows the unit to be wall-mounted, rackmounted, or pole mounted
Plug and play; no software or drivers required
Compatible with all operating systems
Compliant with the Federal Trade Agreements Act (TAA) for GSA Schedule purchases